4 Self Centering Lens Holders
The Self Centering Lens Holders offer reliable and self-centering way for holding
lenses or other round components.Self Centering Lens Holders
can be fitted to any suitable flat surface and can be used for a variety mounting
tasks.Mounts may be attached to series standard rods and then
with series rod holders or series rod translators be located on the table.Camera fitting or two sets of rings to be locked together to mount two telescopes
side by side. They are very useful when lenses must be interchanged frequently and the
height of optical axis should be kept unchanged. They can be mounted on any post.
Self-centring lens mounts reliably centre and safely hold round optics and cylindrical
components. Holding by three rods witch provide easy and secure optics accommodation with
high relocation repeatability. Alternatively, sets of riser blocks and movable bases
provide a selection of convenient, various axis height and direct location to table. |
|
4 Beam Splitter
Mount
The beam splitter splits the laser into two separate beams and also recombines
the beams after they strike the mirrors.Our beam splitter had an
antireflection coating on the side opposite the beam-splitter coating.Beam splitters are sometimes called
"two-way" mirrors. The term 50:50 means that 50% of incident light is reflected
and 50% is transmitted by the beam-splitter coating. Flip optics in and out of the experiment Repeatability Kinematic design Precise
and handy angular adjustment in two orthogonal planes Stable vertical mounting Flip the
platform out and back again. Flipping Mount is made of aluminium and can be anodized in a
color to your request. Designed for ultimate angular positioning performance, these gimbal
mounts have angular contact bearings to minimize stiction. The bearing axes are at 45º
with respect to the adjustment axes so all bearings operate continuously during
adjustment. Two mounting positions 90º apart allow the mount to be rotated to avoid the
possibility of adjusters interfering with the transmitted beam. Spring loaded retaining
plate holds optic stress free.Pillars available for fixing optical axis height in 25 mm
increments
|
|
4 Filter Holder
This is designed especially for ultra cleaning and sterilizing liquids under
positive pressure.In addition this holder can be used for aseptic sampling of liquids or
gases at point-of-use or when samples must be collected and processed on-site.Pressure
type filter holders can be used for ultracleaning or sterilizing liquids and gases. These
have been designed to maximize flow rates and to minimize resistance and can be used in
either batch or continuous filtration procedures. Advantages of pressure filtration Higher
differential pressures are possible, resulting in higher flow rates. Minimize downstream
contamination Avoid downstream foaming Each ballistic nylon filter holder holds one or two
filters. The Filter Holders are sold in packs of two filter . If you are good at math and
stuff, then you might already have figured out that comes to a grand total holding
capacity of up to four filters. For more information on the use of filters, have look at
our resources page. |
